Airlink101 Raven C3210, Как пользоваться инструкцией, Страница: 2 / 21

2 CDMA/GSM connection to a Z-max base
2.1 Modem activation
The modem activation is a procedure that allow to the modem to be registered to the selected
wireless operator. This procedure has only to be done for the first use of the modem. This
procedure must be done for the rover and the base modems.
You should refer to the appendix 1, to activate the CDMA or GSM modem.
2.2 Modem configuration
The modem configuration is a procedure that allow to the modem to be configured in order to
initialize the modem for the base and to dial the base phone number for the rover. In the case
of a connection to a Z-max base, the connection will be based on Circuit Switched Data
connection, with invoice based on the duration of communication. Please refer to you local
wireless operator to know more about billing.
2.2.1 Base side
The Allegro terminal with FastSurvey shall be connected to Z-max either by Bluetooth
wireless link or serial cable to port A.
Port A
Serial cable
or
Bluetooth
In Fast Survey utility you will find, a terminal utility that allow sending command to Z-max.
Send the following commands to Z-max for initializing the base modem:
Commands to send with Allegro terminal connected to port B of Z-max:
Command to send to Z-max
Response from Z-max Comments
$PASHS,SPD,A,9 $PASHR,ACK Set PortA in 115.2Kbps
$PASHS,DSY,A,B<CR><LF> $PASHR,ACK Set Z-max in transparent mode
$PASHS,DSY,B,A<CR><LF> $PASHR,ACK Set Z-max in transparent mode
AT\APASSTHRU<CR><LF> OK Wait 30 seconds before continue
ATS0=1<CR><LF> OK Set the number of ring before
connection
$PASHS,DSY,OFF<CR><LF> $PASHR,ACK Remove the transparent mode
Commands to send with Allegro terminal connected to Z-max through Bluetooth
Command to send to Z-max
Response from Z-max Comments
17/08/2007 2/ 21/