User manual
–
HEPA
Bulle
–
ED02_09-August-2021
4 /31
SECTION 1 -
GENERAL INFORMATION
1.1
SAFETY INSTRUCTIONS
•
READ THESE INSTRUCTIONS THOROUGHLY
and strictly follow the chronological order of
installation, start-up and maintenance steps.
•
If stored or transported at low temperatures, wait at least 1 hour before turning on the equipment.
•
The device must be used at temperatures from +5°C to +35°C, with relative non-condensing
humidity lower than 95%, with dust levels of less than 0.1 mg/m
3
.
•
Do not allow any liquid to penetrate the device.
•
Do not place the device near a heat source.
•
Never obstruct or cover the device inlet (upper grille) or outlets (side grilles) during operation.
•
For prefilter and filter replacement, only use
air
in
space
®
supplies.
•
Disconnect the device’s mains socket before opening it. Do not place your hands near the fan
before it has come to a complete stop.
•
Do not twist, stretch or damage the power supply cable.
•
Only connect the device to earthed sockets that meet legal requirements and are inspected
periodically.
•
Unplug the device when not in use for extended periods.
IMPORTANT:
BEFORE CARRYING OUT ANY WORK ON AN ELECTRICAL COMPONENT,
SWITCH OFF THE DEVICE BY DISCONNECTING IT FROM THE MAINS.
IMPORTANT:
WORK ON THE
HEPA
Bulle
(INCLUDING ELECTRICAL CIRCUITS,
ELECTRONIC BOARDS AND FAN) MUST ONLY BE CARRIED OUT BY
air
in
space
®
MAINTENANCE
PERSONNEL
OR
DULY
TRAINED
PERSONNEL.
THE USER IS LIABLE FOR ANY DAMAGE, REGARDLESS OF ITS NATURE,
CAUSED BY NON-COMPLIANCE WITH THE USAGE RULES AND SAFETY
INSTRUCTIONS.
