Page 5 of 6
The appliance is not intended for use by people with reduced physical, sensory or mental capability
or lack of experience and knowledge, unless they are supervised by a responsible person. Children
should also be supervised at all times when using this hand dryer.
Warning
– in the rare case of a thermal overload (over heating of the motor), a thermostat with
automatic reset protection will suspend the operation of the motor. The thermostat will automatically
reset the motor after 10
– 15 minutes when the specific motor temperature drops below 100
°
C.
General Warnings
Do not use this product for a function different to which it is intended
Do not expose the appliance to the elements such as rain, sun etc.
Do not make any changes to the device
Do not obstruct the air outlet point or air inlet grille
Do not insert any object into the air outlet or air inlet grille
In case of failure/ malfunction, disconnect from the power supply and call your installer
6. Troubleshooting
1. The dryer blows cold air
– the dryer will warm up after use as the heat is generated from the
operation of the motor. This is normal operation.
2. The dryer runs continuously
– decrease the sensitivity of the activation sensor by turning the
white potentiometer on the board located inside the main body of the dryer (see Figure 5)
anti clockwise with a pot adjustor/ small screw driver. Adjust to suit the level of sensitivity
required.
3. The dryer does not operate
– check all connections, if this fails please contact your installer.
Please visit airflow.com/ FAQs for assistance
Figure 5