4
INSTALLATION WITH REMOTE CONTROL (AVAILABLE AS OPTION)
Start with steps 1-2 of the above
fan installation illustration
(without remote control).
3.
Install the remote control
receiver in the bracket as
shown. Make sure that you
do not trap any wires.
4.
Connect the pair of 4-way
male/female connectors from the
bracket to the remote control
receiver and connect the pair of
4-way male/female connectors
from the remote control receiver
to the fan.
5.
Connect wires from supply and
bracket to the wiring terminals as
follows:
Brown wire
Blue wire
Green/yellow striped wire
6
. Stick the infra-red receiver
kit on the ceiling and leave it
outside of the canopy.
Follow the steps 5 to 8 and 10
of the above installation
instructions.
Skip step 9 of the above
installation instructions, as the
pull cords are not necessary
for the use with remote
control.
IMPORTANT:
In order for the remote control to function properly, make sure to set the pull chains to:
-
HIGH position for the fan speed.
-
ON position for the fan light.
OPERATING THE FAN
Check the fan before switching it on!
Risk of injury:
The fan can only be operated if no defects have been found upon inspection.
In case a part is defective, it will have to be replaced before using the fan.
Risk of injury:
Before changing the fan rotating direction, the fan has to be switched off and
come to a complete stop.
Check that the fan is in safe operating condition:
-
Check to make sure that there are no visible defects.
-
Verify that all parts are properly installed and fastened.
Operating the fan and the fan light
The fan can be operated at different speeds by pulling the three-speed switch using the pull cord:
-
First pull: HIGH speed
-
Second pull: MEDIUM speed
-
Third pull: LOW speed
-
Fourth
pull:
OFF
The fan light can be controlled by pulling the on-off switch using the pull cord:
-
First pull: ON
-
Second
pull:
OFF
