DEEP SLEEP QUEEN RAISED AIR MAT TRESS
INSTRUCTION MANUAL - MODEL# 6105QRB
General Care and Maintenance Instructions
Setting Up / Storing Away
Inflating:
Deflating:
Important Safety Information and Warnings:
Clean product with mild soap
and water only.
Do not let product come in
contact with tools, pets, or
sharp objects that may
puncture material.
Do not smoke while
using. Keep away from
open flames.
Never unfold or inflate
the product in cold
temperatures.
• Do not over or under inflate
• CAUTION: After inflation, a change to hot weather will
cause air to expand. You must release air to prevent
airbed from deflating due to overpressure. A change to
cold weather will cause air to contract. You may need to
add air to maintain firmness.
• Avoid using in extreme temperatures.
• Keep away from sharp edges, nails, or any sharp or
pointed objects.
• Do not stand, walk, or jump on bed. Do not allow
children to play or jump on bed.
• Keep away from open flame and heaters.
• Do not smoke on the bed.
• This is not a life saving device. Do not use as a flotation or
as a water toy.
• Do not let young children sleep on this mattress until
mature enough to sleep in an adult bed. Young children
can suffocate, especially in the case of unexpected
deflation. Never leave a child unattended or sleep on
same mattress as a young child.
• Fill with cold air only. Never use a hair dryer to inflate.
• Maximum Weight: 500 Lbs/226 Kgs Total.
1) Check your sorroundings for any sharp objects
on the ground/floor that may cause damage
to the bed (nails, screws, sharp rocks, etc.)
2) Unfold the bed and lay it flat on the floor.
3) Ensure the pump is in the “OFF” position.
4) Connect the pump cord to an electrical outlet
as shown.
5) Make sure the air inlet vents are clear of any
obstructions.
6) Rotate the pump knob clockwise to the
“INFLATE” position as shown.
7) When the air mattress reaches the desired
firmness rotate the pump knob back to the
“OFF” position as shown.
DO NOT OVERINFLATE. INFLATE UNTIL THE
WRINKLES IN PVC ARE ALMOST GONE, AND
THE MATTRESS IS FIRM.
1) Connect the pump cord to an electrical outlet
as shown above.
2) Rotate the pump knob counter-clockwise
past the “OFF” setting to “DEFLATE”
3) Allow the bed to fully deflate, and then turn
the knob to the “OFF” position.
4) Disconnect the pump cord from the outlet
and place it into the cord storage pocket.
5) Fold the bed and place into the carry bag.
OPEN SWITCH
DISCLAIMER:
GREAT CARE AND ATTENTION HAS BEEN TAKEN TO ENSURE THE QUALITY OF THIS PRODUCT. WE
ARE NOT LIABLE FOR ANY ACTIONS THAT MAY RESULT IN INJURY, DEATH, DAMAGE TO PROPERTY,
OR LOSS OF INCOME.
LIMITED WARRANTY:
THIS AIR BED IS GUARANTEED TO BE FREE FROM DEFECTS IN MATERIALS AND WORKMANSHIP FOR
1 YEAR AT THE TIME OF PURCHASE. ANY DAMAGE THAT OCCURS AFTER PURCHASE AS A RESULT
OF NORMAL USE (SCUFFS OR PUNCTURES) IS NOT COVERED BY THIS WARRANTY AND IS THE SOLE
RESPONSIBILITY OF THE CUSTOMER.
INFLATING WITH EMERGENCY FILL VALVE:
IN THE EVENT OF A FAILURE OF THE BUILT-IN PUMP, THIS BED IS EQUIPPED WITH A SECONDARY
INFLATION VALVE. EXTEND SMALL VALVE OUT FROM SIDE OF BED. OPEN VALVE CAP AND FILL BED
WITH EXTERNAL PUMP (NOT INCLUDED). DO NOT USE A HIGH PRESSURE PUMP. A MANUAL PUMP
- SUCH AS A FOOT PUMP OR BIKE PUMP WITH ADAPTER IS RECOMMENDED. CLOSE VALVE CAP
AND PUSH VALVE BACK INTO BED WHEN DONE. DO NOT OVERINFLATE.
CUSTOMER SERVICE: 866-498-5269 | [email protected] / WEB: AIRCOMFORTBEDS.COM / ADDRESS: 4401 SAMUELL BLVD, STE 150, MESQUITE, TX 75149
