Air PreciseAIR PCA Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 30 / 50

IOM-PreciseAIR
Page 30 of 50
3.8. Carel PCO5+ with pGD1
This chapter applies to systems fitted with Carel PCO5+ PLC and pGD1 HMI.
Sample graphic displays are shown below. Contact AIR for details for your specific unit control
system.
3.8.1. HMI
How to Navigate the Screens
All the screens are configured in loops. To navigate through the screens, press the UP and DOWN
arrows.
When the end of the loop is reached, a screen with the message “END LOOP MASK” is
shown and it returns to the first screen of the loop.
To access a specific field within a screen, press ENTER and the cursor will move and blink next to
the value to be changed. When the flashing cursor is next to the field requiring change the user
can change the field value by using the UP and DOWN. Pressing ENTER again to save the new
value and the cursor will move to the next field. Pressing ENTER will continually advance the
cursor on to the next field. When the cursor is blinking again in the top left corner of the screen,
the controller is ready to advance to the next screen using the UP and DOWN buttons.
Press ESC at any time to go back to the previous loop.