16
FX1–3
(continued)
Parameter Description
Value Range
Multitap Delay From
Select the signal where the feedback is taken
from.
Tap 1–5
To
Select the signal where the feedback is sent to. Input, Tap 1–5
Sync
Sync the
Delay
to the
Global Tempo
or turn
Off
to adjust
Delay
by milliseconds or seconds.
Off, On
Low Cut
Center frequency for delay signal low-cut filter.
20.0 Hz – 1.0 kHz
High Cut
Center frequency for delay signal high-cut filter.
1.00 kHz – 20.0 kHz
Delay
Amount of time between the dry signal and the
delayed signal.
When
Sync
is
Off
: 1 ms – 4.00 s
When
Sync
is
On
: 16, 8T, 16D, 8, 4T, 8D, 4, 2T,
4D, 2, 1T, 3/4, 4/4, 5/4, 6/4,
7/4, 8/4
Feedback
Amount of signal fed back into the delay line.
0–100%
Mix
Wet/dry amount of the delay effect.
0–100%
Tap 1–5
Enable or disable each tap delay, which create
multiple delay points.
Off, On
Tap
Delay
1–5
Percent from the original
Delay
value that each
tap delay is set to. At 100%, the tap delay uses
the full Delay amount.
0–100%
Tap Level 1–5
Volume of the tap delay.
-inf – 0.0 dB
Tap Pan 1–5
Stereo panning of the tap delay.
L100 – C – R100
Highpass
Cutoff
Cutoff frequency of the high-pass filter.
0–1000 Hz
Resonance
Amount of resonance of the filter.
0–100%
EQ (3 bands)
Low Gain
Level of the low EQ band.
-15.0 – 0 – +15.0 dB
Low Freq
Center frequency of the low EQ band.
20.0 Hz – 1.00 kHz
Mid Gain
Level of the mid EQ band.
-15.0 – 0 – +15.0 dB
Mid Q
Width of the mid EQ band.
0.50–10.00
Mid Freq
Center frequency of the mid EQ band.
40.0 Hz – 16.0 kHz
High Gain
Level of the high EQ band.
-15.0 – 0 – +15.0 dB
High Freq
Center frequency of the high EQ band.
2.00 – 20.0 kHz
Output
Output level of the post-EQ audio.
-20.0 – 0 – +20.0 dB
