air sniper Induct 300W Standard, Инструкция по эксплуатации, Страница: 8 / 17

8
INSTALLING YOUR UNIT
REQUIRED TOOLS
- Drill bit to initiate cut-out puncture
- Sheet metal tin snips or appropriate cutting equipment
- 12 #8 Tek screws
- Drill for Tek screws
INSTALLATION
CAUTION: Use care when unboxing and handling your unit. Ensure adequate space is
available for unboxing, installation, and operation prior to attempting to handle your unit.
Ensure that the intended placement of your unit allows access to the necessary power
requirements and does not create a hazard once connected.
To Install your Induct 300W Unit:
1. Remove from box
a. Carefully remove your Induct 300W unit, 10’ power cable and reflective
panels from the shipping box
b. Inspect the Unit and all components, note any damage or defects