Air Products GASGUARD TE10, Инструкция по установке, эксплуатации и обслуживанию, Страница: 25 / 196

Section 1: Safety Warnings
Revision - November 2004 Page 1 - 9
Personal protective equipment is designed to protect personnel from inadvertent
risk. The listed personal protective equipment must be worn regardless of operator
or technician level of training and qualifications.
The minimum personal protective equipment required for operating and
maintaining the GASGUARD system is dependent on the hazard category of the
gas(es) being used. When a gas meets more than one hazard category, the PPE for
the most hazardous category
must be used. Refer to the hazard warnings in
Section 1.9 for the hazards of the gas(es) being used.
In addition to the personal protective equipment, the following safety equipment is
highly recommended and is required when APCI personnel operate this equipment.
This equipment should be supplied by the customer prior to operating the
GASGUARD system.
•
Safety shower
•
Emergency phones
•
Eye wash
•
Gas leak detection system for gases to be used (ex: MDA)
The gas leak detection system must warn personnel (through visible and
audible alarms located near the gas cabinet) of a hazardous atmosphere.
The gas sensor(s) need to be set up to alarm at the lowest level of hazard of
exposure. Upon activation of an alarm, follow the established shutdown
procedures for your system.
•
Scrubber with a pollution abatement system sized for maximum potential
upset flow of hazardous gas.
•
Adequate ventilation as described in section 3.7.
If you are unsure what personal protective
equipment list to follow for the gases being
used, DO NOT continue. Failure to
understand the hazards and use the proper
personal protective equipment may cause
INJURY or DEATH. Contact Air Products
and Chemicals, Inc. for the gas category.