Air innovations WINE GUARDIAN DS025, Инструкция по установке, эксплуатации и обслуживанию, Страница: 35 / 61

35
1. Disconnect the communication cable from the side of the
Wine Guardian unit and the remote sensor. Route the
communication cable within the wall and/or ceiling
structure of the wine cellar to the desired controller
mounting location.
2. Plan on mounting the remote sensor on a solid surface
away from doors, corners, air outlets, drafts or heat
generating equipment. Do not mount the remote sensor
directly on an outside wall, a wall adjacent to a boiler
room, or other hot area. Use a piece of foam insulation
behind the sensor to insulate it from a hot or cold surface.
The recommended height is
5ft to 6ft (1.5m to 1.8m)
above
the finished floor.
3.
Remove the remote sensor’s face plate (Fig. 1) and mark
the mounting points at the desired location within the wine
cellar (Fig. 2). Also, mark the location of the
communication cable connection as this area will require
sufficient clearance, for the cable to exit the wall and
attach to the back of the sensor.
4. Drill two
1/8” holes and insert anchors within the mounting
surface. Anchors may not be required if securing to a wall
stud or racking system. Insert the screws into the holes
and test fit the backing plate for mounting to ensure it
mounts easily onto the two screws and slides down onto
the slotted openings freely. (Fig. 3)
Installation of the Wine Guardian Remote Sensor
The wireless remote sensor is a combination temperature and
humidity sensor only. It is designed to be mounted within the wine
cellar and can be used in combination with the remote interface
controller or up to two additional remote sensors to read and control
multiple areas within the wine cellar.
For a wired application you will require a RJ-9 communication
cable.
Mounting the Remote Sensor (Wired)
Fig. 1
Fig. 2
Fig. 3