Air innovations 99H0360-10, Инструкция по установке, эксплуатации и обслуживанию, Страница: 43 / 85

43
quarter inch, a vibration eliminator should be installed close to the motor compressor in a
horizontal parallel to the compressor, crankshaft or in a vertical position 90 degrees to
compressor crankshaft.
NOTE: The suction line should be clamped near the inlet end of the vibration
eliminator. The vibration eliminator is located between the clamp and the
compressor.
Split System Interconnecting Line Sizing Chart
Table 3
Model Liquid
Line(OD) Liquid
connection
at
evaporator
(OD) Suction
line (OD) Min.
Suction line
insulation
thickness
(in) Suction
connection
at
evaporator
(OD) Maximum
“total” l ine
length
Maximum
lift
(height)
DS025 1/4” 1/4” 3/8” 3/8” 3/8” 50’ 15’
DS050 1/4” 1/4” 1/2 ” 3/8” * 3/8” 50’ 15’
DS088 3/8” *1/4” 5/8” 5/8” *1/2” 50’ 15’
DS200 3/8” 3/8”
¾”
5/8” *1/2” 50’ 15’
*Interconnecting tube must be reduced down at evaporator connection
50Hz Models
Model Liquid
Line(OD)
Liquid
connection
at
evaporator
(OD)
Suction
line (OD) Min.
Suction line
insulation
thickness
(in) Suction
connection
at
evaporator
(OD) Maximum
“total” line
length Maximum lift
(height)
WGS40
0.635cm 0.635cm 0.952cm 0.952cm 0.952cm 15.24 meters 4.57 meters
WGS75
0.635cm 0.635cm 1.27cm 0.952cm 0.952cm 1 15.24 meters 4.57 meters
WGS100
0.952cm 0.635cm 1.59cm 1.59cm
1.27cm
2
15.24 meters 4.57 meters
WGS175
0.952cm 0.952cm 1.905cm 1.59cm
1.27cm
3
15.24 meters 4.57 meters
Notes:
•
Line lengths are expressed in equivalent feet = actual run fitting
allowances (i.e.
~5’ for each bend/elbow allowance).
•
Use only refrigeration grade dehydrated tubing.
60Hz Models
1
Use ½” (1.27cm) to 3/8” (0.952cm) reducer at evaporator
2
Use 5/8” (1.59cm) to ½” (1.27cm) reducer at evaporator
3
Use ¾” (1.91cm) to 1/2” (1.27cm) reducer at evaporator