2-29
Chapter 2: FUNCTIONS AND OPERATION
Step 2.
Manual Scan
2-1.
Stopping and restarting automatic scan
To continuously monitor a specified station, press the [0] key when that station is displayed to stop
automatic scan operation. Pressing the [0] key again restores automatic scan operation.
2-2.
Advancing a scan
Pressing the [
] key advances the scan by one station.
2-3.
Moving back a scan
Pressing the [
] key moves the scan back one station.
2-4.
Warning the monitored station by voice
To transmit a voice warning to the monitored station, press the Push-to-talk key.
Step 3.
Scan Monitor end
To end Scan monitor, either press the Clear key or replace the handset.
4.2. PBX Connection (only when the AN-8000MI is used)
If the Multi interface unit is connected to the PBX's analog E&M interface, calls or conversations can be
mutually made between the AN-8000 system's stations and the PBX's extension telephones or paging calls
can be initiated from the PBX extension telephone.
4.2.1. Calling the PBX extension telephone
Step 1.
Dial the analog E&M interface access number at a AN-8000 system's station.
The station is connected to a PBX.
Step 2.
Confirm that a dial tone from the PBX is heard, then dial the PBX extension number.
The extension telephone is called.
Note
Set the analog E&M interface access number using the supplied AN-8000 software. (Refer to
Confirmation tone
Analog E&M interface
access No.
PBX extension No.
Call
Calling tone
Telephone
X
Y
Y
Y
4.2.2. Being called from a PBX extension telephone
Dialing the intercom access number as well as the AN-8000
system's station number at the PBX extension telephone
permits the AN-8000 system's station to be called.
The method for receiving a call from the PBX extension
telephone at the AN-8000 system's station is the same as
when it is called by another station within the system.
Note
Set the intercom access number at the PBX.
Calling tone
Call
Y
Intercom
access No.
AN-8000 system's station No.
X
X
X
Содержание AN-8000EX
Страница 225: ...Chapter 8 APPENDIX ...