Aim AXC-FDX-2, Руководство по оборудованию, Страница: 11 / 31

2 . Instalation
AXC-FDX-2 Hardware Manual 3
2
INSTALATION
2.1 Preparation and Precaution for Installation
The AXC-FDX-2 features full XMC Plug and Play capability, therefore, there are no
jumpers or switches on the board that require modification by the user in order to
interface to the XMC bus.
It is recommended to use a wrist strap for any installations. If there is no wrist wrap
available, then touch a metal plate on your system to ground yourself and discharge any
static electricity during the installation work.
2.2 Installation Instructions
The following instructions tell how to install the AXC-FDX-2 module in your system.
Please follow the instructions carefully, to avoid any damage on the device.

To Install the AXC-FDX-2
1. Switch off your system and all peripheral devices.
2. Unplug the power cord from the wall outlet. (Inserting or removing
modules with power applied may result in damage to module devices).
3. Touch a metal plate on your system to ground yourself and discharge any
static electricity.
4. Remove the carrier board from the system slot.
5. Replace the XMC Slot filler panel from the host front panel.
6. Place the AXC-FDX-2 mezzanine module on top of the carrier board, with
the XMC connectors on the AXC-FDX-2 aligned with the corresponding
connectors on the carrier board (see Figure 2-1).
Take care for correct size of the Bezel with ESD-gasket on ESD surface in
host front panel, and the correct size of the voltage keying pins.
7. Then connect the XMC connectors smoothly.
8. Align the standoffs on the AXC-FDX-2 module with the carrier board.
Install the screws through the holes in the carrier board and the spacers.
Tighten the screws.
9. Install the complete board into its proper card slot. Ensure the module is
seated properly in the backplane connectors. Take care not to damage or
bend connector pins. Secure the board.
10. Replace the cover of your system.
11. Connect the system to the power source. Turn on the power to your
system.