Aim ANET1553-1, Руководство пользователя

Страница: 28 / 57

20 ANET1553
Users
Manual
3.1.4.6 Reset Settings to Factory default
Click on the Maintenance tab in the navigation bar (see the figure below).
“Reset To Factory Defaults” allows to reset all settings to the factory defaults.
To do this first go to the Update Tab and re-boot the ANET1553 to Maintenance mode
by a mouse click to the “Reset to maintenance system” button. Then wait until the
ANET1553 is in Maintenance mode. Log-In again and go back to the Maintenance Tab
to press the OK button on “Reset all settings now”.
After resetting the settings, the password will be set to the factory defa
ult (“aim”), the
Network Settings will be set to DHCP mode and the services SSH and ANS1553 will be
enabled.
Figure 3-8 ANET Web Configuration Tool
“Maintenance”
3.1.5 Updating the ANET1553 module
Click on the
“ Update”
tab in the navigation.
Re-boot the ANET1553 to switch to maintenance mode.
Wait until the re-boot has been finished, then log-in (re-connect) to the ANET1553
again. Click again on the
“ Update”
tab in the navigation bar and choose the update-file
(<filename>.tar.gz), e.g. anet1553-update.tar.gz and start the update.