AIC N 100 WH, Руководство по установке и обслуживанию

Страница: 20 / 80

Heating circuit 1
DHW
3
OK ESC
1
2
0 4 8 12 16 20 24
OK ESC
4
0 4 8 12 16 20 24
OK ESC
U-20
Z-038791_EN • Rev A
I
nstructIons for the
u
ser
Basic Settings
Setting Procedure Controls/Screens
Heating mode
selection
Push on the Heating mode selection button to toggle from one
mode to the other:
• Automatic mode ( ) (to be programmed, refer to
“Boiler Settings for the Installer” on page I-60.
• Comfort mode ( )
• Reduced mode ( )
• Protection mode ( )
For a description of the heating modes, refer to “Symbols and
Messages on the Control Panel” on page G-11.
Temperature
setpoint for the
Comfort and the
Reduced modes
1. When in Comfort mode, rotate the knob (
1
) to adjust
the temperature setpoint.
Alternatively, the setting can be performed through the menus
1.
Press the OK button (
2
) to access the end user menu.
2. Rotate the knob (
1
) to scroll through the menu until
“Heating circuit 1” (
3
) is highlighted.
3. Press the OK button (
2
) to validate the selection
4. Rotate the knob (
1
) to select “Room comfort setpoint”
5. Press the OK button (
2
) to validate the selection.
6. Rotate the knob to increase/decrease the temperature
to the desired value.
7. Press the OK button (
2
) to save the setting.
8. Rotate the knob (
1
) to select “Room reduced setpoint”
9. Press the OK button (
2
) to validate the selection.
10. Rotate the knob to increase/decrease the temperature
to the desired value.
11. Press the OK button (
2
) to save the setting.
12. Press the Heating Mode Selection button (
4
) to go
back to the home screen.
î
When a mode is selected, it is marked by a black line underneath.
î
Pressing the ESC button (
8
) will cancel the ongoing setting operation and return to the home
screen without saving the settings.
î
When the setting process is interrupted for more than 8 minutes, the controller automatically
returns to the home screen without saving the settings.
i
8