AIC Wireless
•
304 N. Isabella Street
•
PO Box 5189
•
Sylvester, GA 31791
•
229-‐776-‐2510 (O)
•
229-‐776-‐2512 (F)
General
This document covers the mounting, wiring and
initial start-‐up of the Aurora WIO-‐4UI Wireless
Sedona® Controller. The Aurora Wireless Sedona®
Controllers only operate on the JACE controllers on
the Niagara Framework®. It is assumed that the
installing technician is a certified Niagara-‐AX
technician and is familiar with the Sedona
Framework®.
Product Description
The Aurora WIO-‐4UI is a user configurable wireless
controller operating on the Sedona Framework®
using wireless 2.4GHz Mesh technology by Jennic.
The WIO-‐4UI has 4 Universal Inputs (supporting
temperature, resistance, voltage, and current).
Before Installation
•
Unpack the AUR-‐WIO-‐4UI
•
Inspect the device for missing or broken
pieces/components
•
Read all included instructions prior to use
Included in this Package
Included in this package you should find the
following:
•
AUR-‐WIO-‐4UI Wireless Controller
•
4 – 2 Position Connectors (5.08mm)
•
1 – 2 Position Power Connector (7.5mm)
•
1 – 2dBi Antenna, RPSMA
•
1 – Installation Instructions
•
4 – 500Ω Resistors
Safety Instructions
The following instructions are general guidelines
for proper installation of the device. Any questions
should be directed to AIC Wireless prior to install.
It is the responsibility of the installer to ensure all
local, state and federal codes are followed.
•
Disconnect all power prior to install
•
Make all connections in accordance with
local and national electrical codes
•
This device is used for monitoring and
control, not intended for life safety
applications
•
Discharge any static electricity prior to
handling the device. Static discharge
produce voltages high enough to damage
electronic components
•
Do not handle the bare PCB (Printed Circuit
Board) without proper protection against
static discharge
AUR-‐WIO-‐4UI Wireless Controller
INSTALLATION INSTRUCTIONS
