8 Settings
- 64
–
Set a time zone
Measured data will be stored in the wireless sensor with a timestamp.
To be sure that the timestamp does not show the time set in the data
logger but rather the Coordinated Universal Time (UTC) the time
zone in which the data logger and the wireless sensor are located
must be set on the data logger.
7. Tap on the field next to
Time zone.
8. Enter the desired time zone. In doing so, enter the number of hours
that are added to the Coordinated Universal Time (UTC) (positive, e.g.
for Europe/Berlin 2 during summer time, 1 during winter time) or
deducted from the Coordinated Universal Time (UTC) (negative, e.g.
for America/New York -4 during summer time, -5 during winter time).
8.1.8 How to set the Data Storage Mode
In the data storage mode
“ring memory”, the oldest data
of a running measurement will be overwritten when the
memory is full.
In the data storage mode “linear memory”, the measuring
operation will stop automatically when the memory is full.
When a measurement has been started, the arrows of the
icon are
flashing in the upper line of the display
1
.
In case the data storage mode “ring memory” is enabled,
the arrows flash in
orange
In case the
data storage mode “linear memory” is
enabled, the arrows flash in
blue
.
!
No measurement may be started.
1. In the home screen, tap on Memory
.
2. In the line
Ring memory
tick the checkbox if you want to choose the
ring memory; leave the checkbox unticked if you want to choose the
linear memory.
