Agromehanika AGT 106, Руководство по эксплуатации

Страница: 127 / 245

OPERATING INSTRUCTIONS AGT 1060 Rev.09/2020
126
Fig. 147
7.2 USING THE ROLL BAR
Before starting to work, always make sure that the roll bar is properly installed in the
upright position.
The roll bar can only be lowered when the nature of work does not allow otherwise, but only
over short distances and in areas where there is no danger of rollover. When the roll bar is
lowered, the driver MUST NOT fasten the safety belt and must pay particular attention because
he is not protected.
To lower the roll bar, follow the procedure below.
•
Before lowering the roll bar, make sure that the operating area is safe to avoid any
injuries when handling the roll bar.
•
Remove the safety pin (1) and pull out the bolt (2).
•
Slowly lower the roll bar to the horizontal position. To make this task easier, move your
grip and your body to the left and right when it is lowered.
•
While lowering the roll bar, take care to avoid injuries from rear-view mirrors. It is
recommended to move them inwards before lowering, refer to the chapter “Adjustment of
rear-view mirrors”.
•
When the work is finished, make sure that the roll bar is moved to the appropriate
position.
•
Insert the bolt (2) and the safety pin (1) back and block the roll bar in place.
WARNING: Lowering the roll bar may result in injuries if your body posture is
not appropriate, which is why this task must be carried out with caution.
DANGER: Do not use the safety belt when driving with the roll bar lowered.