Agromehanika AGS 2500 EN-HP, Инструкция по эксплуатации

Страница: 18 / 131

USER MANUAL – rev.2016/12 AGS 2500/3000 EN-HP
page
8

The sprayer pump receives the power from the connecting shaft of the tractor by means of
the cardan shaft. Drive parts can cause serious injuries so, in order to avoid that , follow
the instructions below:

To drive the pump a cardan shaft must be used which characteristics are in
accordance with the recommendations of the manufacturer and is fitted with a
protection cover.

Connect the machine to the tractor only if the drive shaft (PTO) is turned off.

Connecting and disconnecting of the cardan shaft must be performed only when the
engine is shut off.

Before activating the drive shaft (PTO) check the number of revolutions and make
sure that there are no people or animals in the danger area of the machine.

The cardan shaft should be cleaned and greased only when the drive shaft (PTO) is
turned off, the engine shut down and the start key removed.

Do not engage the drive shaft of the tractor (PTO) without a reason and check if the
difference of cardan joint angles is not excessive.
WARNING: Do not engage the drive shaft of the tractor (PTO) with the engine
not running!
2.15 Safe maintenance

Before starting to operate the machine learn how to maintain it.

Keep the working place clean and dry.

Do not grease, maintain or adjust the machine while it is moving! Do not touch
moving parts of the machine! Turn off the machine and make sure that there is no
working pressure in the circulation of the chemicals!

Do not maintain or service the machine before it is thoroughly cleaned.

During maintenance and servicing of the machine, remove the start key or disconnect
the connections.

Disconnect the drive shaft of the tractor (PTO) to prevent sudden actuation and
operation of the machine.

Do not inspect the machine without "turning on" safety elements.

Do not perform reparatory welding on the machine, if you have used ammonium
nitrate or any other liquid that contains ammonium nitrate for sprinkling without
having thoroughly cleaned the machine before.

Do not enter the reservoir to repair or clean it.

Support and safely mount all parts that need to be lifted during maintenance.

Keep all of the sprayer’s parts in good condition. Repair damages immediately.
Replace worn and damaged parts. Remove excess oil, grease or any other debris.

Disconnect the battery before you start to adjust the electrical system or perform
welding on the machine.

During maintenance of the machine or cleaning the nozzles use appropriate protection
equipment in accordance with the regulations.
 It is strictly forbidden to release chemicals into the environment.
2.16 Road transport
Do not drive the machine on public roads. If you have to, you must consider the following
instructions: