Agromehanika AGS 2500 EN-HP, Инструкция по эксплуатации

Страница: 122 / 131

USER MANUAL – rev.2016/12 AGS 2500/3000 EN-HP
page
112
15
GENERAL INSTRUCTIONS FOR SPRAYING
For a successful spraying, the appropriate water quantity, right nozzle selection and a precise
consumption calculation are of major impotence. It is recommended to stick to the following
order when it comes to preparing of the spraying mixture and spraying:
Make sure that the spraying appliance is in flawless condition. Check the oil level of the
pump and clean all filters.

Read the instructions which are attached to the protective agent. Pay special attention to
the prescribed concentration, the dose for a hectare and the recommended water
consumption.

Choose an appropriate tractor speed and – if you do not have a reliable value – measure
it. It is very important to have precise speed values when it comes calculating the
quantity of the mixture.

Choose appropriate nozzle type and size according to the crop and required water
consumption. Use the nozzle tables.

Fill the reservoir with half of the fresh water you will need.

Adjust the working pressure on the regulator and check the liquid flow rate through the
nozzles.

Calculate the required water consumption per hectare according to the measured liquid
flow rate through the nozzles and the working speed.

Fill the reservoir with the mixture and add the required water quantity.

While working, pay attention to a constant working speed, the height of the spraying
equipment, the working pressure and nozzle operation.

Clean the sprayer after you finish working.
WARNING: Sprayer is NOT SUITABLE FOR USE LIQUID FERTILIZER!
In case of emergency use, we recommend consultation with our technical service!