Agromehanika AGS 2500 EN-HP, Инструкция по эксплуатации

Страница: 116 / 131

USER MANUAL – rev.2016/12 AGS 2500/3000 EN-HP
page
106
Therefore, in case of poor sealing or leaking:
- DO NOT TIGHTEN the joint too hard, since you can easily damage it. Take the joint
apart and check the condition and position of the sealing or the O-ring, clean and grease it
and reassemble the joint.
- Use only non-mineral lubricant (bio-lubricants) for lubrication.
NOTE:
- Radial sealing – manual tightening of fitting is adequate.
- Axial sealing – apply small force with hand tool.
13.2.6 Drive shaft – cardan
It is important that the safety pin, which is attached to the head of the cardan shaft, is clean
and greased. This assures that the shaft is safe to use.
Check the protective cover, the functioning and the condition of the cardan shaft every 40
working hours. Replace damaged parts with new ones.
Check the protective cover of the cardan shaft every 100 working hours and, if necessary,
replace the sliding plates of the protection. Also check the condition of the cardan shaft. Pay
special attention to the safety pin. Replace damaged parts with new ones.
13.2.7 Bolts
IMPORTANT: Check bolts, pins and especially safety pins, their tightness and their
condition. If necessary, tighten or replace them. The information on the necessary bolt
tightness can be found in the table bolt tightening torque (chapter 13.3).
13.2.8 Pump
After spraying season, thoroughly clean the inside and the outside of the pump and prepare it
for storage. Check the quantity of working hours and, if necessary, repair the pump (oil
change, diaphragm change, sealing change, etc.) or at least check the oil level, the sealing, etc.
This is the most appropriate time of the season to perform some maintenance work. If you are
not sure whether or not you can repair the pump on your own, leave the work to an authorized
expert. Description of maintenance tasks is provided in chapter “PUMPS”.
13.2.9 Other parts
The rest of the vital parts such as filter inserts, pouring sieve, additional equipment, etc. must
be thoroughly cleaned, checked and replaced if necessary, too. Remove the remaining water
and eventual sediments from parts such as suction filters and three-way valves. Grease all
moving and sliding parts of the sprayer.
WARNING: If the temperatures go below zero, protect the spraying device against
cold to prevent damage!