INSTRUCTIONS FOR USE
AGS 400 - 1200 EN
Rev.12/2018
11
•
The sprayer pump receives the power from the connecting shaft of the tractor by means of the
cardan shaft. Drive parts can cause serious injuries so, in order to avoid that , follow the
instructions below:
o
To drive the pump a cardan shaft must be used which characteristics are in accordance with
the recommendations of the manufacturer and is fitted with a protection cover.
o
Connect the machine to the tractor only if the drive shaft (PTO) is turned off.
o
Connecting and disconnecting of the cardan shaft must be performed only when the engine is
shut off.
o
Before activating the drive shaft (PTO) check the number of revolutions and make sure that
there are no people or animals in the danger area of the machine.
o
The cardan shaft should be cleaned and greased only when the drive shaft (PTO) is turned off,
the engine shut down and the start key removed.
o
Do not engage the drive shaft of the tractor (PTO) without a reason and check if the difference
of cardan joint angles is not excessive.
WARNING: Do not engage the drive shaft of the tractor (PTO) with the
engine not running!
2.15
SAFE MAINTENANCE
•
Before starting to operate the machine learn how to maintain it.
•
Keep the working place clean and dry.
•
Do not grease, maintain or adjust the machine while it is moving! Do not touch moving parts of
the machine! Turn off the machine and make sure that there is no working pressure in the
circulation of the chemicals!
•
Do not maintain or service the machine before it is thoroughly cleaned.
•
During maintenance and servicing of the machine, remove the start key or disconnect the
connections.
•
Disconnect the drive shaft of the tractor (PTO) to prevent sudden actuation and operation of the
machine.
•
Do not inspect the machine without "turning on" safety elements.
•
Do not perform reparatory welding on the machine, if you have used ammonium nitrate or any
other liquid that contains ammonium nitrate for spraying without having thoroughly cleaned
the machine before.
•
Do not enter the reservoir to repair or clean it.
•
Support and safely mount all parts that need to be lifted during maintenance.
•
Keep all of the sprayer’s parts in good condition. Repair damages immediately. Replace worn
and damaged parts. Remove excess oil, grease or any other debris.
•
Disconnect the battery before you start to adjust the electrical system or perform welding on
the machine.
•
During maintenance of the machine or cleaning the nozzles use appropriate protection
equipment in accordance with the regulations.
•
It is strictly forbidden to release chemicals into the environment.
