10
aTTaCH PUSH TUBeS TO THe BULkHead
STeP 15:
(See fIGURe 15)
•
With a push tube (15) level to the hitch mount
assembly (2), insert the uncapped end of the push
tube into the bulkhead (12) hole at that height.
•
Repeat with the second push tube.
•
Secure each push tube to the bulkhead using a
washer (O) and hair cotter pin (P).
P
O
15
15
2
12
P
P
O
O
fIGURe 15
STeP 16:
(See fIGURe 16)
•
Attach the two push tubes (15) together using a clevis
pin (Q) and a spacer (R) between the push tubes at
the end closest to the bulkhead.
•
Insert a second clevis pin through the opposite side of
the push tubes at the end furthest from the bulkhead.
•
Secure each clevis pin using a hair cotter pin (P).
Note:
We recommend the two hair cotter pins (P) be on
opposite sides of the push tubes (15).
•
Push a cap (U) onto the end of each push tube.
Q
Q
P
R
P
R
15
U
U
fIGURe 16
