19
ELECTRIC ATTACHMENT CLUTCHES
FIGURE 42
TENSIONING CHAIN (JJ)
LEFT FRONT HOLE
STEP 43: (SEE FIGURE 43)
• Hook the spring from the parts bag through the end of
the tensioning chain.
• Hook the other end of the spring onto the bottom of
the bolt and nut which secure the idler pulley to the
upper idler arm. Hold the bolt head and assemble a
3/8" hex lock nut (Z) onto the bolt, leaving enough
space for the spring to pivot freely between the two
nuts.
• Attach a 3/32" hairpin cotter (FF) to the chain, placing
it in the fi fth link from the spring.
CHAIN
(L.H. SIDE)
3/32" HAIR
COTTER PIN (FF)
5TH LINK
LEFT
SIDE
3/8" HEX
LOCK NUT (Z)
SPRING
RIGHT
SIDE
ATTACH
SPRING
HERE
STEP 44: (SEE TABLE 2)
•
Two different length drive belts are included with
your snow thrower. Use the table below to select
the correct drive belt for your type tractor. The part
number is printed on the outside of the belt .
•
Set aside the belt that is not for your tractor to avoid
accidentally using it.
55" BELT (PART #46989)
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
56" BELT (PART #48138)
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
(LT) Lawn Tractor
48"
Electric
(LT) Lawn Tractor
48"
Electric
(LT) Lawn Tractor
38", 42", 46"
Electric
(LT) Lawn Tractor
38", 42", 46"
Electric
(LT) Lawn Tractor
38", 42", 46"
Electric
(LT) Lawn Tractor
38", 42", 46"
Electric
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
(LT) Lawn Tractor
48"
Electric
TRACTOR TYPE
DECK SIZE
CLUTCH TYPE
(LT) Lawn Tractor
48"
Electric
TABLE 2
STEP 41: (SEE FIGURE 41)
• Attach the two suspension arms to the rear of the
clutch/idler assembly using two 5/16" x 3/4" hex bolts
(C), 5/16" washer (Q) and 5/16" nylock nuts (Y) for
each arm. Place the arms on the outside of the frame
with the notches to the rear.
FIGURE 41
STEP 42: (SEE FIGURE 42)
• Pace the extra tensioning chain (JJ) through the left
front hole in the clutch/idler assembly and then turn
the assembly upside down.
5/16" NYLOCK
NUT (Y)
5/16" x 3/4"
HEX BOLT (C)
5/16" WASHER (Q)
