9
STEP 12:
(SEE FIGURE 13)
•
Select the control cable with two threaded ends.
Select the threaded end that has no rubber cap
or nuts and assemble a 5/16" hex jam nut (T)
approximately 3/4" onto the threads. Insert the
threaded end of the cable through the round hole
in the cable mount bracket (GG) and secure it with
another 5/16" hex jam nut (T).
Tighten
the second nut
while keeping the first nut in place.
•
Assemble the ball end of the cable wire up through
the hole in a cable end fitting (LL) and then slide it
back inside the curled edge of the fitting.
STEP 13:
(SEE FIGURE 14)
•
Attach the cable end fitting (LL) and the long spacer
(U) to the left hand hole in the channel and lift bracket
using a 1/4" x 1-1/2" hex bolt (N) and 1/4" nylock nut
(R).
Tighten
, keeping the cable end fitting aligned
with the threaded end of the cable.
FIGURE 12
FIGURE 14
STEP 14:
(SEE FIGURE 15)
•
Attach the lift bracket to the right hand hole in the
channel, next to the long spacer. Use a 5/16" x 3/4"
hex bolt (G) and 5/16" nylock nut (V).
•
Attach the frame assembly to the channel assembly.
Fit one side of the frame assembly onto the 3/4" rod
of the channel and then fit the other side onto the rod.
Secure each side with a 3/4" washer (BB) and a 1/8"
x 1-1/4" cotter pin (O).
STEP 11:
(SEE FIGURE 12)
•
Assemble a 3/8" x 1-1/4" carriage bolt (K) through
the cable mount bracket (GG) and then mount it
from the left side to the square holes in the angle
lock bars. Secure the bracket at the angle shown in
figure 14 with a 3/8" nylock nut (Q).
CABLE MOUNT
BRACKET (GG)
ANGLE
LOCK
BARS
3/8" X 1-1/4"
CARRIAGE BOLT (K)
3/8" NYLOCK NUT (Q)
CHANNEL
LIFT BRACKET
LONG SPACER (U)
1/4" X 1-1/2"
HEX BOLT (N)
1/4" NYLOCK NUT (R)
CABLE END
FITTING (ll)
CABLE MOUNT BRACKET
FIGURE 13
CONTROL CABLE END
CABLE
MOUNT
BRACKET (GG)
3/4"
5/16" HEX
JAM NUTS (T)
CABLE END
FITTING (LL)
BALL END
CABLE
FIGURE 15
LIFT BRACKET
3/4" ROD
3/4" WASHER (BB)
1/8" x 1-1/4"
COTTER PIN (O)
5/16" X 3/4" BOLT (G)
5/16" NYLOCK
NUT (V)
FRAME ASSEMBLY
