Agreto Swis721 LT BT Standart, Руководство пользователя, Страница: 7 / 20

AGRETO Animal Scale
© AGRETO electronics GmbH Seite:7
6 Assembly of scale
The components of the scale are delivered in three boxes. The appliance can be
assembled by one person.
Please follow the assembly instructions below.
6.1 Assembly of base frame
required mounting material size pieces
hex bolt M8x20 4
washer M8 4
spring washer M8 4
Lay the frame part with the wheel
fastenings sideways on a flat surface. Be
careful not to damage the attached cables.
The wheel mounts on the frame must face
outwards.
Add the floor panel. The edging of the floor
panel must point in the direction of the feet.
Screw the front side of the floor panel to the frame part with 2 screws from the inside
to the outside.
Repeat the process with the frame part with the handles on the other side of the floor
panel. The handles must point outwards. The side with the wheels is referred to as
"front" in this manual, the side with the handles as "rear". The directions left and right
are seen from the handle side.
Then place the balance on the floor with the feet.