AGRETO AgriCounter Load
© AGRETO electronics GmbH
page:11
Parameter SENS - Sensitivity (operating mode 3B)
This parameter determines from which intensity of a movement the count is
triggered, ie how strong the vibration or movement must be. The higher the
value, the stronger the movement must be to trigger or continue the count.
0 = highest sensitivity (counts even on very small movements)
2 = a running internal combustion engine is already detected
4 = default
10 = lowest sensitivity (only counts for extreme movements)
The parameter SENS is related to the parameter hoLd, since a movement must
always have a certain intensity and must be present for a certain period of time
in order to trigger the summation.
Parameter hoLd – Holding time (operating mode 3B)
In idle mode, this parameter determines the time in seconds that the counter
waits after a first move to actually start the totalization permanently. If there is
another movement within the set time (which is strong enough), the time from
the first movement is added up and the counter is in counting mode. If there is
no further movement within the set time, the counting is stopped and the sum is
reset to the initial value.
1 = summation starts immediately after the first movement
20 = default
100 = summation is started after 100 seconds
In counting mode, this parameter determines the length of a rest period in
seconds, during which the count continues without interruption. If another
movement follows within the set time (which is strong enough), the complete
time is added up, including the rest phase. If the rest period lasts longer than
the set time, the count stops and the sum is reset to the value at the beginning
of the rest phase. The meter is now in idle mode.
1 = summation is stopped immediately at the end of the movement
20 = default
100 = A rest period of up to 100 seconds is counted
