03
05
07
This detail shows the port cog
123-03
viewed from the
port side. Turn the cog so that the ribs on the cog (red
arrows) are positioned as shown, with one against the
rib on the inside of the hull (yellow arrow).
118-01
123-03
123-06
118-01
123-06
123-03
123-04
123-03
118-01
PWM
123-04
04
06
08
This shows cog
123-03
correctly positioned in the port
side of the stern
118-01
: note that the teeth point
towards the centre of the hull, as indicated.
Insert the shaft of the first rudder
123-06
up into
the hole on the port side of stern section
118-01
,
as shown.
The shaped end of the shaft of the rudder fits into a
corresponding recess in the cog. Fix the rudder
123-06
in place using a
PWM
screw, inserted through the cog
and the raised socket and into the rudder shaft.
Fit the starboard cog
123-04
(marked R) on the raised
socket on the starboard side of the stern section
118-01
. Make sure the ribs are aligned correctly, so that
the rib on the inside of the hull is between the ribs on
the cog.
Ensure that the ribs of cog
123-04
are in the correct
position and the teeth are facing towards the centre
of the hull. Note that with the cogs
123-04
and
123-03
in the correct positions, the rudders are parallel.
28
28
AGORA
MODELS
29
AGORA
MODELS
