17 Technical Information
TwisTorr Medium-TMP
onboard
Controller Installation
Side Mounting
NOTE
The L-shaped bracket (P/N X3511-68003) is available as an option.
See the following figure.
8
Place the L-shaped bracket on the controller, with the pump
cable toward the bracket, and fix it by means of the three socket
head screws M5, the washers and the nuts. The 6 holes on the
bracket allows to mount the controller with the rotation angle
that you like;
9
Turn the pump upside-down;
10
Place the bracket on the pump bottom (the hole on the bracket
has the same diameter as the pump bottom flange);
11
Screw a little bit the three screws M6 in the holes on the pump
bottom;
12
Rotate the bracket until the controller is on the chosen position;
13
Tighten the screws properly;
14
Turn the pump again;
15
Plug the line card and connect the pump cable to the pump;
16
Connect the mating connector with the jumper on the interlock
signal to start the pump.
Figure 20 Side Mounting
174/181
TwisTorr Medium-TMP
onboard
Controller User Manual /
87-901-050-01 (B)