Agilent Technologies R Series, Руководство пользователя

Страница: 84 / 220

Chapter 3: Setting up the BenchCel Workstation
BenchCel Microplate Handling Workstation R-Series User Guide
50
Setup Workflow
About this topic
This topic presents the workflow for setting up the BenchCel Workstation
for operation.
Workflow
The following table presents the steps for setting up the BenchCel
Workstation. After setting up the BenchCel Workstation for the first time,
you will not likely change any of the settings in the procedure unless you
add a device, replace a device, or move the BenchCel Workstation.
!! IMPORTANT !!
Before proceeding to step 6 (setting
teachpoints), you should already have definitions for the labware
you want to use. Although you can define labware at any time
before step 6, Velocity11 recommends that you define labware
before setting up the BenchCel Workstation. For instructions on how
to define labware in the BenchWorks software, see the BenchWorks
Automation Control User Guide.
Step
For this task... See...
1 “Starting up and shutting down the
BenchCel Workstation” on page 52
2 “Creating and deleting a BenchCel device in
BenchWorks” on page 54
3 “Creating and managing profiles” on
page 60
4 User documentation for the Velocity11
device or the
Device Driver Guide for third-
party devices
5 User documentation for the Velocity11
device or the
Device Driver Guide for third-
party devices
6 “Setting and managing teachpoints” on
page 66
7 BenchWorks Automation Control User Guide
Start up the workstation.
Create a device file and add
the BenchCel device in
BenchWorks.
Create a profile.
Add external devices to the
device file.
Create a profile for each
external device.
Add another device
to the device file?
Set and edit teachpoints for
external devices.
Write protocols.
Yes
No