Agilent Technologies PlateLoc, Руководство пользователя

Страница: 46 / 144

Chapter 2: Unpacking and installation
PlateLoc User Guide
32
Checking the air
connections
To check the air connections:
1. With the air source turned off, gently tug the air tubing at each
connection.
If you feel resistance at the connection, the tubing has been properly
installed.
2. Turn on the air source.
3. Listen near each connection for hissing sounds that might indicate a
leak.
If you hear hissing sounds, turn off the air at the source and on the
back of the PlateLoc, check and tighten the connections, and then
turn on the air again. If the problem persists, contact your facilities
department or Velocity11 Technical Support.
Disconnecting the
air source !! DAMAGE HAZARD !!
Do not pull the tubing out of the orange
quick disconnect fitting. Doing so can damage the fitting.
To disconnect the air tubing from the PlateLoc:
1. Turn off the air at the source (house, cylinder, or pump).
2. Turn off the air on the back of the PlateLoc.
3. Push and hold the locking collar against the fitting, and then gently
pull the air tubing out.
Note: Alternatively, you can use the SMC Pneumatics tool (TG-2)
to aid in this task. See the manufacturer’s documentation for use
instructions. Contact your local SMC parts supplier for ordering
details.
The following diagram shows a close-up view of the quick
disconnect fitting.
Push and hold the locking collar.
Gently pull out the tubing.