Agilent Technologies PlateLoc, Руководство пользователя

Страница: 33 / 144

19 Chapter 1: PlateLoc introduction
PlateLoc User Guide
General precautions
!! INJURY HAZARD !! Do not attempt to remove the PlateLoc
covers and disassemble the device. Doing so can cause injuries and
damage the device.
!! INJURY HAZARD !! Using controls, making adjustments, or
performing procedures other than those specified in this user guide
can expose you to hot surfaces, high pressure gases, and moving
parts. Exposure to these hazards can cause severe injury.
The PlateLoc is designed for safe operation. Under normal operating
conditions, you are protected from high temperature, high pressure, and
moving parts. However, you should be aware of these hazards and
understand how to avoid being exposed to them.
Chemical hazards !! INJURY HAZARD !!
Chemicals that have low flash points (such
as reagents that are used in radioactive scintillation proximity
assays (SPAs) and solvents, including alcohols) must not be used in
the PlateLoc.
Some chemicals used when working with the PlateLoc can be
hazardous. Make sure you follow your local, state, and federal safety
regulations when using and disposing of the chemicals.
Read the recommendations in the MSDS (Material Safety Data Sheet) for
every chemical that you plan to use. The manufacturer of the chemical
should provide you with the MSDS.
Argon gas (Gas-
Purging Platelocs
only) !! INJURY HAZARD !!
Argon is an odorless, colorless, and
nontoxic gas that can cause rapid suffocation by displacing air.
Argon is heavier than air and can flow into low areas.
Always use argon in a well-ventilated area. Always turn off the argon
source when the PlateLoc is not in use.
You should set up an oxygen monitor in the lab to prevent accidental
suffocation. The oxygen monitor can set off an alarm if the oxygen level
falls below the acceptable threshold.
Gas cylinders and
pressure regulators
Follow the local, state, and federal safety codes for the placement and
mounting of gas cylinders. For example, you might have to attach a
standard cylinder bracket to a solid permanent structure to meet or
exceed all local seismic and safety requirements.
Always use good lab practices when handling high-pressure cylinders.
Make sure you follow any instructions provided with the cylinders.