Agilent Technologies M1205A V24, Руководство по обслуживанию, Страница: 294 / 358

$JLOHQW0$996HULHV6HUYLFH*XLGH
5HPRYLQJ 5HSODFLQJ3OXJLQ0RGXOHV
Remo
vi
ng &
Rep
lac
in
g
Plu
g
-in
Mo
du
les
1%33XPS
7R5HPRYHWKH1%33XPS
6WHS
Using a small screwdriver or similar tool, unplug the white 4-pin connector from
the socket through the access hole on the top rear module casing.
6WHS
Grip and pull the red pump block assembly from the air inlet connector and the
module assembly.
7R5HSODFHWKH1%33XPS
6WHS
Remove the protective cap from the air inlet connector on the pump module.
6WHS
Facing the front of the module, locate the pump assembly into the left side of the
module assembly. Ensure the air inlet tube fits properly into the air inlet connector
of the pump.
6WHS
Using a small screwdriver or similar tool, plug the white 4-pin connector into the
socket on the module assembly. To gain access to the connector, carefully lift the
PCB on the opposing side of the module assembly.
6WHS
Once the pump is in place, locate the PCB into its original position and reassemble
the module. Perform the NBP module specification test in this manual. Calibration
is required if the test fails.
7KH1%3SXPS
LQIODWHVWKH
SUHVVXUHFXII
Disassemble the
module down to
the frame
Remove the
Pump
Replace Parts