Agilent Technologies E3646A, Руководство пользователя, Страница: 88 / 211

Chapter 4 Remote Interface Reference
Output Setting and Operation Commands
88
MEASure[:VOLTage]?
Query the voltage measured at the sense terminals of the power supply.
OUTPut:TRACk[:STATe] {ON | OFF}
Enable or disable the power supply to operate in the track mode. See “Tracking
Operation” on page 46 for more information on tracking operation. At
*RST , the track
mode is disabled.
OUTPut:TRACk[:STATe]?
Query the tracking mode state of the power supply. The returned value is ‘‘0’’ (OFF)
or ‘‘1’’ (ON).
VOLTage {
<voltage>
| MINimum | MAXimum | UP | DOWN}
Program the immediate voltage level of the power supply. The immediate level is the
voltage value of the output terminals.
The
VOLTage command changes the output of the power supply to the newly
programmed value regardless of the output range presently selected.
This command also increases or decreases the immediate voltage level using the
‘‘
UP
’’ or ‘‘
DOWN
’’ parameter by a predetermined amount. The command
VOLTage:STEP sets the amount of increase or decrease. Notice that a new
increment setting will cause an execution error -222 (Data out of range) when the
maximum or the minimum rated voltage is exceeded.
VOLTage? [MINimum | MAXimum]
Query the presently programmed voltage level of the power supply.