Agilent Technologies E2969A, Руководство пользователя

Страница: 18 / 52

Installation Testing the Installation
2-10 E2969-91020
Testing the Installation
After installing hardware and software as described above, you should
test the installation before starting to test your devices. This section
provides some hints:
•
When powering up the target platform, watch the four-digit display on
the test card. The numbers indicate the states of the internal link state
machine.
After some state switching, the four-digit should settle showing “xx10”.
The two digits on the right indicate the state of the link between the
test card and the target platform. The digits “10” show that the link
could be established.
If the display settles at any other number, an error has occurred (see
“Troubleshooting” on page 4-1 ).
The left two digits indicate the state of the line between the test card
and an add-in card plugged into the test card. If there is no card
plugged onto the test card, this state is not relevant.
Linux
•
While Linux boots up, make sure to start the uni-processor kernel and
log in as root.
Open a terminal window and enter
lspci
to get a list of all PCI devices
found in the system. This list should contain two unknown devices
with the vendor ID 1855, indicating the two bridges contained in the
PTC: