Agilent Technologies Agilent 33500 Series, Руководство по эксплуатации и обслуживанию

Страница: 302 / 429

SYSTem Subsystem
SYSTem:COMMunicate:GPIB:ADDRess {<
address
>}
SYSTem:COMMunicate:GPIB:ADDRess?
Assigns instrument's GPIB (IEEE-488) address, which is displayed at power-on. Each device on the GPIB interface
must have a unique address.
Parameter Typical Return
0 to 30, default 10 +15
Set GPIB address to 15:
SYST:COMM:GPIB:ADDR 15
l
Your computer's GPIB interface card has its own address. Avoid using this address for any instrument on the GPIB
bus.
l
This setting is non-volatile; it will not be changed by power cycling or *RST .
l
SYSTem:SECurity:IMMediate sets GPIB address to 10.
l
Must cycle power for this command to take effect.
SYSTem:DATE <
yyyy
>, <
mm
>, <
dd
>
SYSTem:DATE?
Sets system clock date.
Parameter Typical Return
< yyyy > 2000 to 2100
< mm > 1 to 12
< dd > 1 to 31
2011,07,26
Set system date to July 26, 2011:
SYST:DAT 2010, 7,26
SYSTem:ERRor?
Reads and clears one error from error queue.
Parameter Typical Return
(none) -113,"Undefined header"
Read and clear first error in error queue:
SYST:ERR?
l
Up to 20 command syntax or hardware errors can be stored in the error queue.
l
Error retrieval is first-in-first-out (FIFO), and errors are cleared as you read them. The instrument beeps once
each time an error is generated (unless disabled by
SYSTem:BEEPer:STATe OFF ).
Agilent 33500 Series Operating and Service Guide 301