Agilent Technologies 83236B, Руководство по эксплуатации, Страница: 105 / 164

105
Chapter 4, GPIB Commands
COMPensation Subsystem
COMPensation[:RFG1]:TEMPerature:REQuest:STATe?
[{0|1|2|3|4|5| <numeric> [HZ|KHZ|MAHZ|MHZ|GHZ]}]
Used to check if the RF generator compensations at the specified frequency band
or value are required based on the temperature change since the last
compensation. If the frequency band or value is not specified, the frequency value
specified by the
RX:OUTP:FREQ
is used. This command measures the current
temperature and compares it to the previously stored value. (Query only)
0:
800 to 859 MHz band (Compensation frequency: 840 MHz)
1:
859 to 960 MHz band (Compensation frequency: 880 MHz)
2:
1710 to 1785 MHz band (Compensation frequency: 1750 MHz)
3:
1805 to <1850 MHz band (Compensation frequency: 1830 MHz)
4:
1850 to 1910 MHz band (Compensation frequency: 1880 MHz)
5:
1930 to 1990 MHz band (Compensation frequency: 1960 MHz)
<numeric>:
800 to 859 MHz, 859 to 960 MHz, 1710 to 1785 MHz, 1805 to
1850 MHz, 1850 to 1910 MHz, 1930 to 1990 MHz (Compensation
frequency is rounded off to 840 MHz, 880 MHz, 1750 MHz,
1830 MHz, 1880 MHz, or 1960 MHz.) If the entered value is out of
range, the value is rounded off to the appropriate limit value. (The
default unit is “Hz”.)
• Response to the Query
{0|1} <new line><^END>
0:
The temperature change is less than the value defined by the
COMP:TEMP:REQ:RES command. The temperature
compensation is not required.
1:
The temperature change is greater than the value defined by the
COMP:TEMP:REQ:RES command. The temperature
compensation is required.