Agilent Technologies 2200 TapeStation, Руководство пользователя

Страница: 21 / 72

2200 TapeStation 21
Installing the System
3
Installing the System
Agilent 2200 TapeStation Set Up
1 Connect the supplied USB cable between the port on the back of the
instrument and your laptop.
2 Power the instrument with the supplied power lead and adaptor.
3 Turn the instrument on using the power switch located at the back of the
TapeStation.
When powered and idle, the instrument will have a blue LED visible on the
front of the case.
Hardware required Laptop
Software required Agilent 2200 ScreenPlex Software (already installed)
TestKitSuite.xml file from Test Kit Manufacturer
WA R N I N G
Personal injury, explosion or fire
➔
Do not operate the instrument in an atmosphere containing explosive gases or near
flammable volatile liquids.
➔
Only approved mains cord set supplied with the instrument must be used with this
instrument and if an extension lead is required, the lead must be earthed.
➔
If the equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
N O T E
For general safety information, please refer to the 2200 TapeStation System - Site and
Safety Manual .
WA R N I N G
Use of unsupplied cables or power adaptors
Using cables or power adaptors not supplied by Agilent Technologies can lead to
damage of the electronic components or personal injury.
➔
Never use cables or power adaptors other than the ones supplied by Agilent
Technologies to ensure proper functionality and compliance with safety or EMC
regulations.