Agilent Technologies 11982A, Руководство по эксплуатации и обслуживанию

Страница: 31 / 70

2-2
Installation and Preparation for Use
Preparing the Agilent 11982A for Use
Preparing the Agilent 11982A for Use
Initial Inspection
Inspect the Agilent 11982A shipping container for damage. If the shipping
container or cushioning material is damaged, keep it until you have verified
that the contents are complete and you have tested the lightwave converter
mechanically and electrically.
The Agilent 11982A is packed within a carton as shown in Figure 2-1 on
page 2-3 . Table 2-1 on page 2-3 contains the description and part numbers of
the packaging materials. Table 2-2 on page 2-3 contains the accessories
shipped with the lightwave converter. If the contents are incomplete or if the
lightwave converter does not pass the verification test (this procedure is pro-
vided in
Chapter 4, “Verification and Service Information” ), notify the nearest
Agilent Technologies office. If the shipping container is damaged or the cush-
ioning material shows signs of stress, also notify the carrier. Keep the shipping
materials for the carrier’s inspection. The Agilent Technologies office will
arrange for repair or replacement without waiting for a claim settlement.
If the shipping materials are in good condition, retain them for possible future
use. You may wish to ship the lightwave converter to another location or to
return it to Agilent Technologies for service. See
“Returning the Instrument
for Service” on page 4-4 .