38
8210-00001 R0
Figure 11.
Chain Coupler Location
7.6. Inspect Hydraulic Hoses and Fittings
Æ
When equipped:
1. Pressurize the system.
2. Using a piece of cardboard or wood, run it along the length of the hose and around all fittings.
Escaping hydraulic fluid under pressure will cause serious injury if it penetrates the skin
surface.
3. Replace the hose or tighten/replace the fitting if a leak is found. For replacement hoses, refer to
.
4. Replace any hose that is badly cut, nicked, abraded, or is separating from the crimped end of the fitting.
5. Secure hoses to the machine.
7.7. Inspect the Hopper Flashing
Check hopper flashing for wear and replace any that are worn. Worn flashing will cause hopper leakage.
7.8. Check the Roller Bearings
Check the roller bearings for wear. Any rollers making noise, getting hot while running, or that give should be
replaced.
7.9. Check the Roller Lagging
Inspect roller lagging to see if it is showing signs of wear.
PTO TOP-DRIVE FIELD LOADER – PORTABLE GRAIN BELT CONVEYOR
