10
P1512115 R8
2.5.1 Gas Engine Safety
Power Source
• Keep guards in place and secure.
• Properly ventilate surrounding area.
• Never fill the fuel tank with the engine running, while
smoking, or near an open flame. Always shut down and allow
engine to cool before filling with fuel.
• Never overfill the tank or spill fuel. If fuel is spilled, clean it
up immediately.
• Be sure to use the correct type and grade of fuel. Ground the
fuel funnel or nozzle against the filler neck to prevent sparks
that could ignite fuel vapors.
• Be sure to replace the fuel fill cap when you are done.
Lockout
• For engines with an electric start, remove the ignition key,
the spark plug wire, or the spark plug.
• For engines with a rope or crank start, remove the spark plug
wire or the spark plug.
2.5.2 Electric Motor Safety
Power Source
• Electric motors and controls shall be installed and serviced by
a qualified electrician and must meet all local codes and
standards.
• A magnetic starter should be used to protect your motor.
• You must have a manual reset button.
• Reset and motor starting controls must be located so that the
operator has full view of the entire operation.
• Locate main power disconnect switch within reach from
ground level to permit ready access in case of an emergency.
• Motor must be properly grounded.
• Guards must be in place and secure.
• Ensure electrical wiring and cords remain in good condition;
replace if necessary.
• Use a totally enclosed electric motor if operating in
extremely dusty conditions.
S E R V I C E D I S C O N N E C T
ON
OFF
Lockout
• The main power disconnect switch should be in the locked position during shutdown or
whenever maintenance is performed.
• If reset is required, disconnect all power
before
resetting motor.
PORTABLE GRAIN BELT CONVEYOR – FIELD LOADER
