8210–00011 R1
53
Section 7.9 – Inspect the Hopper Flashing on page 56
Section 7.10 – Check the Roller Bearings on page 56
Section 7.11 – Check the Rollers on page 56
Section 7.14 – Inspect Belt Lacing on page 60
Section 7.6 – Check the Gearbox Oil on page 55
Annually:
Section 7.5 – Oil the Chain Coupler on page 54
Section 7.12 – Tension the Conveyor Belt on page 56
Section 7.13 – Align the Conveyor Belt on page 58
Section 7.17 – Clean and Wash the Equipment on page 62
2–3 Years:
Section 7.15 – Replace the Belt Lacing on page 61
Section 7.7 – Change the Gearbox Oil on page 55
Section 7.20 – Inspect and Service the Hydraulic Winch and Lift Cable on page 65
As Required:
Section 7.18 – Repack the Wheel Bearings with Grease on page 63
Section 7.19 – Check/Adjust the Truss Cables on page 63
Section 7.16 – Replace the Conveyor Belt on page 61
7.3. Visually Inspect the Equipment
Lock out power before inspecting.
Check the following during a visual inspection:
1. Ensure all guards are in place and in good working order.
2. Examine the conveyor for damage or unusual wear.
3. Check tightness of bolts/nuts, fasteners, and hardware (re-torque if necessary).
4. Be sure all safety decals are in place and are legible.
5. Check that the discharge and intake area are free of obstructions.
6. Inspect all moving or rotating parts to see if anything has become entangled in them. Remove any entangled
material.
Æ
7.
When equipped:
Inspect hydraulic hoses and fittings for leaks and wear. Fix or replace where necessary.
8. Check wheel bolts are tight and examine tires for gashes, uneven wear, or loss of air pressure. See
for recommended tire pressure and torque information.
9. Check all operating, lifting, and transport components. Replace damaged or worn parts before using the
conveyor.
SWING-AWAY CONVEYOR – PORTABLE GRAIN BELT CONVEYOR
