AGFEO AC 14 USB, Руководство пользователя, Страница: 35 / 76

O - 25 Operation
O
Connection costs
Cost menu – Overview:
Your telecommunications system can record the
costs of calls if your network operator offers the
ISDN feature “Transfer connection costs at the
end of the call” and the providers you use also
transmit these.
For technical reasons the data on the telephone
bill may differ from the connection cost totals of
your telecommunications system. The network
operator’s tariff unit counter is always the last in-
stance.
PIN (Personal Identity Number) – You can protect
access to the costs menu by entering a 4-digit
cost PIN. If you hear the busy tone when you start
the cost menu, you have to enter the cost PIN
after
*KOS
. If you hear the short acknowl-
edgement tone, no PIN is defined for the cost
menu.
If you forget the cost PIN, you can change it with
TK-Set on the PC or contact your dealer.
Set decimal places - before entering the factor
for a charging unit set the number of decimal
places which you wish to be shown. 0 to 3 decimal
places are possible.
Factor for a tariff unit – Use the maximum 4-
digit user factor (e.g. 0,121 DM per unit) to define
how much a tariff unit costs for every internal
subscriber.
With the maximum 4-digit
basic factor , set your
telecommunications system to the amount (e.g.
0,121 DM per unit) which the network operator
charges for one tariff unit.
Limit / Disconnect at limit – You can define a 7-
digit cost limit (Pfennigs) for every internal sub-
scriber. You can also define what is to happen
when the cost limit is reached. Can the internal
subscriber continue the conversation he has
begun but not start a new external call or will the
connection be cut off. The subscriber can only
make external calls again after clearing his total
costs.
Exception: The direct phone number can also be
dialled on reaching the limit.
Communication of charge pulses on / off - On
an analog telephone, you can display connection
costs if the telephone has a units counter. To
display connection costs, you must activate
communication of the charge pulses for your tel-
ephone on your telephone.
If you have requested the "communication of
connection charges during of the connection"
feature from your network carrier, your telephone
continuously displays the costs during a
connection.
Define charge pulses -The charge pulse the PBX
sends to analog telephones may be switched from
16 kHz to 12 kHz.
The analog phones available in Germany usually
use the 16 kHz-pulse.
Your PABX can transmit charge pulses to analog
telephones only, if your operator provides the
ISDN function "Advice of charge" and your
network provider is able to transmit them.
As-delivered state:
- PIN no entry
- 2 decimal digits
- User factor 0,12 DM
- Basic factor (network operator) 0,12 DM
- Limit no entry
- Disconnect at limit off
- Cost log off for all subscribers
- Transmission of charge pulses activeted
- Charge pulses: 16 kHz
N. B.! You cannot telephone as long as the cost
menu is started. You hear the special dialling tone
when you Lift handset. You cannot telephone
again until the cost menu has been exited.