AGFA DRYSTAR AXYS, Руководство по обслуживанию

Страница: 64 / 461

DD+DIS033.07E
Controls, Connections and Setup Procedure
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1 DRYSTAR AXYS Chapter 1 / 28
06-2008 Type 5367/100 Agfa Company Confidential
5.4.4 Basic Image Adjustment at the Printer via Key-Operator Menu
NOTE:
•
Via key-operator menu only the parameters Look-up table, Interpolation and
Dmax can be adjusted.
•
Before these parameters can be changed, the modality has to be configured at
the printer. This is done either via Printer Installation Wizard or via key-operator
function "3 Change Settings - 5 Image Quality - 3 Add modality".
•
This creates a DICOM Host Profile with the settings as defined in the printer
modality database (Corresponding printer parameter of the Installation wizard or
"Add modality" function: "Brand").
U
Important remark:
U
Changing parameter via key-operator menu does not
automatically ensure that the value is applied.
Two situations can be distinguished:
o
U
In case the modality does not send a parameter
U
(e.g. no Dmax value sent),
the value set in the printer is applied to the modality print job.
o
In case the modality sends a parameter value , (e.g. Dmax = 2.8 O.D.) this
value still has priority above the value set in the printer. Even when an empty
value (" ") is sent.
This means, the value sent by the modality has higher priority than the value set in
the printer, and therefore it is always preferred to set the required parameter value at
the side of the modality.
If this cannot be done contact your local Application Specialist.