AGFA DRYSTAR AXYS, Руководство по обслуживанию

Страница: 285 / 461

DD+DIS033.07E
Repair and Service
Adjustments and Calibrations
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1 DRYSTAR AXYS Chapter 3.6 / 33
06-2008 Type 5367/100 Agfa Company Confidential
Select densitometer: 4 Dmax = 305
Square Measured density Target density Density diff. Check
100% 20 20 0 0
90% 46 48,5 -2,5 0
80% 74 77 -3 0
70% 102 105,5 -3,5 0
Density Reproduction = OK
60% 130 134 -4 0
No CDM calibration needed for DT2B film
50% 158 162,5 -4,5 0
40% 186 191 -5 0
30% 215 219,5 -4,5 0
20% 244 248 -4 0
10% 270 276,5 -6,5 0
0% 300 305 -5 0
When entering the measured density values the decimal point appears in a different spot, e.g. measured value = 0.23, value to enter = 23.0
Density Lower limit Upper limit
0 0 0
30 -3 3
45 -4 4
60 -5 5
75 -6 6
90 -7 7
X-rite 310
105 -8 8 X-rite 331
120 -9 9
X-rite 341
135 -9 9
X-rite 301
150 -9 9 Mac Beth TR924
165 -9 9
Gretag D200-2
180 -10 10
195 -10 10
210 -10 10
225 -10 10
240 -10 10
255 -11 11
270 -11 11
285 -11 11
300 -11 11
315 -12 12
Density difference SMPTE image DT2B film DSAXYS
-15
-10
-5
0
5
10
15
0 50 100 150 200 250 300 350
Target Density
De
n
s
it
y
Dif
fe
re
nce
Lower limit
Upper limit
Density difference
X-rite 341
Figure 19
(4) After the measured values are filled in, the density reproduction is calculated
automatically.
(5) At the right hand side of the table is shown, whether the Density Reproduction is
ok or not. In case it is not ok you are requested to carry out a CDM calibration.
3.2 Check for dust stripes / TPH Cleaning Procedure
TO BE
DONE
•
Whenever dust stripes seem to be present
•
During troubleshooting procedure.
(1) Check the films for dust stripes as described in the flowchart of
Figure 20.