AGFA Anapurna H3200i LED, Руководство для продвинутых операторов

Страница: 47 / 50

47
:Anapurna H3200i LED Advanced Operator Manual (v1.0)
5.7 Procedure: Holiday shutdown (Long-Term)
All the components of the printer are powered off during a long-term shutdown.
Time required for this procedure is between 30 and 60 minutes.
Procedure:
1 Perform a prime check to verify that all print heads are functioning correctly, see 7.2.1.
2 If any nozzles are blocked they must be cleared.
3 On the front panel: switch off the vacuum of the media transport belt.
4 Remove the media used for the prime check.
5 Move the shuttle to the home position (it lowers itself to its minimum height).
Normally the shuttle is in the home position.
6 Fill the white ink circuit with storage flush, follow the procedure of section 7.6.1.
7 Wait until the automatic fill process is completed before continuing with this procedure.
This will take about 20 minutes.
Notes:
• In preparing for a shutdown the operator should ensure that all jets in the print heads are clear to
avoid any problem with a blockage expanding or becoming more fixed in place during the down
time. This is why the procedures start with a prime check.
8 On the iGUI: turn off the delivery pumps for white ink
and storage flush, see also section 4.4.2.1.
9 Switch off the white ink vacuum [1].
10 Press and hold the purge button [2] for 3 seconds.
Storage flush flows out of the white head.
11 Repeat step 10 (approx 20x) till no more storage flush
is flowing out of the white head.
12 Clean the base plate, see section 10.3.2.
13 On the control screen: press button [Home Cover] to
close the home cover.
14 Close all color ink valves [3].
15 Switch off the color ink vacuum [4].
16 Close the iGUI program.
17 Shut-down Windows and wait for the shutdown to be
complete, blue indicator lamp [11] goes off.
18 On the front panel:
- switch off vacuum [7]
- switch off media set [8]
- switch off media tension [9].
19 Push at least one emergency stop button to secure the
printer, white indicators [5] and [10] go off.
20 Turn off the electrical power with the main power
switch [6] on the back panel.
21 Lockout the main switch, see section 2.10.
2 4
3
1
Note:
After the printer is turned off with the main power
switch, the display on the shuttle stays on till the
voltage of the backup battery is around 40%.
5
7
8 9 10
11
6