AGCO Massey Ferguson 9195, Руководство по обслуживанию

Страница: 33 / 41

General Information
02-12 4283440M1
Motor Shaft Splines
FIG. 18: Apply grease to the motor (1) shaft splines and
the spline hub when the motor is removed for service.
Fill the spline area in the spline hub with grease. Apply
grease to the splines on the motor shaft. Make sure that
the cavity in the gearbox is partially filled with grease.
Cutterbed
IMPORTANT: Change oil in the cutterbed after the first
40, 140, and 240 hours of operation. Also
change oil in the cutterbed at the beginning of
each season thereafter, or every 250 hours of
operation, whichever comes first.
IMPORTANT: The oil level in the cutterbed must be
correct. Do not overfill the cutterbed. Excess oil
will cause failure of the cutterbed due to
overheating.
The oil level in the cutterbed cannot be checked. If in
doubt as to the amount of oil in the cutterbed, drain the
cutterbed and fill with the correct type and quantity of
lubricant. See Lubrication in the Specifications section for
the correct type and quantity of lubricant.
Drain the cutterbed when oil is warm. If the oil is cold, idle
machine for approximately 10 minutes before draining. To
change the cutterbed oil, park the machine on a solid level
surface.
Raise the header all the way and engage the header lift
cylinder stops, if equipped. Put the header angle at zero
degrees. This will help drain the oil toward the drain plug
at the rear of the cutterbed. Stop the engine and take the
key with you.
Tilting the cutterbed will let any contamination move
toward the drain plug at the left-hand of the cutterbed. To
tilt the cutterbed, put an jackstand extended to about 406
mm (16 in) under the right-hand end of the cutterbed. Put
a 203 mm (8 in) block under the left-hand end of the
cutterbed. Disengage the header lift cylinder stops, if
equipped. Start the engine and lower the header until the
cutterbed is on the jackstand and the block. Stop the
engine and take the key with you.
FIG. 18
1
R0629593