AGCO LELY RPC 130 F, Оригинальное руководство оператора

Страница: 87 / 168

3.3.4 Place or Remove the Wheel Chocks
Procedure
1.
When the machine is not in use and not
connected to the tractor, the wheel chocks
(1) must be in position.
2.
You can put the wheel chocks in the holder
(2) on the rear right side of the machine.
NOTE:
Make sure that you remove the
wheel chocks before you start to move with
a connected machine.
GUID-EA88E736-A0CA-4221-9737-47BEAE5D3953-high.jpg [High]
Fig. 26
(1) Wheel Chock
(2) Holder
3.3.5 Drain the Air Container of the Pneumatic Brake System
Before starting the procedure
NOTE:
This procedure only applies if the machine has a pneumatic brake system.
Drain the air container of the pneumatic brake system each day.
NOTE:
You must replace the air container if:
• The air container type plate is missing
• It is not possible to read the data on the type plate
• The type plate is not attached correctly.
Procedure
1.
Pull the pin of the drain valve of the air
container.
a) If necessary, put a wire through the hole
in the pin to pull the pin.
2.
Hold the pin pulled until no more water
comes out.
3.
Pressurize the air container to a minimum of
5 bar (72 psi) with the pneumatic system of
the tractor (read the pressure gauge of the
pneumatic system of the tractor).
GUID-FE04F401-F44F-435D-B2E5-5AB284B61D50-high.jpg [High]
Fig. 27
GUID-FBA002DA-52CC-4E05-8796-2D92DABE4D0F [V1]
GUID-C9BF170C-2FA6-418D-89CF-4B35CBF3A76D [V1]
3. Operation
Baler Wrapper Combination 87
4900.LE.EN01