AGCO GSI 40 Series, Руководство по монтажу, Страница: 16 / 164

Chapter 2: General Overview
Anchor Bolt Detail
The following is the minimum requirement for anchoring of standard tanks. Refer to sidedraw instructions
for special anchoring details.
• 5/8 in. diameter anchor bolt (A) is the minimum allowed, 3/4 in. diameter anchor bolt (A) is the mini-
mum with side draw flume system.
• Exposed anchor bolt thread height (B ) for 5/8 in. and 3/4 in. diameter anchor bolts are 3 in. (7.6 cm)
and 5 in. (12.7 cm) respectively.
• Overall anchor bolt length (C) for 5/8 in. and 3/4 in. diameter anchor bolts are 14 in. (35.56 cm) and
18 in. (45.72 cm) respectively.
Figure 2-1 Anchor bolt example (3/4 in. diameter anchor bolt shown)
A Anchor bolt C
Anchor bolt length
B
Anchor bolt thread height
Anchor Bolt Charts
Prior to setting any anchor bolts, you must be sure to have the correct anchor bolt placement. This is very
critical for stiffener alignment during bin erection.
NOTE: Refer to the proper chart to find the anchor chord dimensions that correspond to the bin that is
being built.
Start with one anchor bolt and work from it to the left to locate one quarter of the anchor bolts then to the
right to locate another quarter of the bolts. Working off of the last anchor bolts in each quarter, locate the
remaining anchor bolts in the last two quarters.
16 Pneg-4460A 60 Ft Diameter 40-Series Bins