AGCO GSI 40 Series, Руководство по монтажу, Страница: 138 / 164

Chapter 9: Accessories
Table 9-2 Peak-to-Exhauster Ladder Rung Kit
Bin Diameter
Location 36 ft. 42 ft. 48 ft. 54 ft. 60 ft. 72 ft.
↑
Bin Peak
19 LS-260-1
18 LS-260-2
Bolt Hole
Count
Located on
the Roof Rib
17 LS-260-3
16 LS-260-2 LS-260-3
15 LS-260-4
14 LS-260-3 LS-260-5
13 LS-260-3 LS-260-4 LS-260-6
12 LS-260-4 LS-260-5
11 LS-260-3 LS-260-5 LS-260-6
10 LS-260-5 LS-260-6
9 LS-260-4 LS-260-7
8 LS-260-6 LS-260-8
7 LS-260-8
6 LS-260-10
Bin Eave
↓
5
4
NOTE: The table above shows the correct ladder step and part number to be installed in the correspond-
ing hole in the roof rib. Shaded areas show the correct roof exhauster ladder step and part
number with the corresponding hole in the roof rib.
Preparation for Roof Exhauster Installation
Before installing the roof exhauster, some preparation is required, utilizing the roof exhauster mounting
plate and the roof panels that span the roof exhauster mounting plate.
Before You Begin
Determine the location of the roof exhauster and set aside the roof panels that the roof exhauster mount-
ing plate will span.
What You Should Know
This procedure is to cut the exhauster airflow hole. Use the roof exhauster mounting plate as a template
to determine the correct location for field drilling and cutting the roof exhauster hole.
1. Position the roof panels (K) spanned by the roof exhauster mounting plate on the ground. Align the
roof panel holes as if they are installed on the bin.
2. Temporarily install the roof exhauster mounting plate (F) to the roof panels (K) using bolts (G) and
nuts (E), ensuring all holes are aligned and the teeth of the roof exhauster mounting plate (F) are
nestled in between two roof ribs. Also field drill all required holes (H) on the roof panels (K).
3. Using the roof exhauster mounting plate (F), mark or scribe the hole (I) to be cut.
Tip
If tabs are already bent, flip the mounting plate upside down to scribe the hole location.
138 Pneg-4460A 60 Ft Diameter 40-Series Bins